FS10

Product outline

FS10 is a digitizer module for strain gauge type sensors for force, pressure, and displacement measurements. A very accurate measurement can be achieved with the high sampling rate of 1200 sps. This product is ideal for test and experiment applications.

Compact, light, and simple to use!

With FS10, you can monitor the load cell outputs on PC easily.

USB software

You can simply plug a load cell into FS10 via a cable and connect it to PC via USB.
(Once PC is connected to FS10, it will start downloading the USB driver automatically if it is connected to Internet).

■ Pass/fail test
　High & low limit function: HH/HI/LO/LL
■ Easy to perform the initial setup and calibration
　Using the software, settings can be saved and edited on PC, and calibration can be performed as well.
■ Waveform display
　The waveform of force can be monitored in real time.
　You can see if the real-time value is within the high/low, and the data of waveform can be saved on PC as well.
■ Data recoding
　Up to 10000 measurement and status (e.g. HI, LO, etc…) data can be recorded.
　Interval logging is available, and it is useful for long-hour loading tests and so on.
　With the OK/NG (Not OK) count function, you can review results of pass/fail tests as well.

＜Waveform display＞

＜Data logging＞

＜Setup & calibration＞

Specifications

Analog section｜Display section｜Interface｜General specifications｜Attachments

Analog section
Excitation voltage	DC 5 V±10%, Output current within 30 mA
Signal input range	-3.0 to +3.0 mV/V
Accuracy	Non-linearity: within 0.02% FS±1 digit Zero drift: within 0.5 μV/℃ Gain drift: within 0.01%/℃
Digital low-pass filter	fc＝OFF, 2, 4, 6, 8, 10, 30, 50, 100 Hz (selectable)
A/D converter	Speed: 1200 times/sec. (Same for data output) Resolution: 24 bit (binary) Approx. 1/30000 with respect to 3 mV/V

Display section
LED status light	LED (Red): Power supply/alarm status LED (Green): Loaded condition

Interface
USB	USB interface

General performance
Power supply	DC 5 V (USB bus power)
Power consumption	1 W typ.
Operating conditions	Temperature: Operation: -10℃ to +40℃, Storage: -40℃ to +80℃ Humidity: 80% RH or less (non-condensing)
Dimensions	50(W) × 23(H) × 80(D) mm (Not incliding projections)
Weight	Approx. 120 g

Attachments
Setup guide	1
Cable for connecting load cell 1 m	1
USB cable (A-miniB type) 1.8 m	1

Optional accessories

Model
CA81-USB	USB cable (A-miniB type) 1.8 m
CA903Y30	Cable with waterproof plastic connector at one-end 0.3 m
CA903Y31	Cable with waterproof plastic connector at one-end 3 m
CA904030	Waterproof plastic connector-PRC connector conversion relay cable 0.3 m
CA904031	Waterproof plastic connector-PRC connector conversion relay cable 3 m
CN90	Waterproof plastic connector for load cell

---

Please note that there are possibilities of individual differences in a color tone on display devices such as LEDs, fluorescent display tubes and LCDs due to manufacturing process or production lots.

---

Download

Product catalogue(PDF)		⇒Download Page
Operation manual(PDF)
External dimension	DXF （ZIP）
	PDF
Support tools
Software